OPERATION AND USE
PNEUMATIC LINE CONNECTION
The pneumatic supply at site (to which the pneumatic system of the lift is connected) must be
connected to the supplied lubricator. For the connection of the pneumatic lines proceed as follow:
 Mount the lubricator on the rear of the post;
 Connect the pneumatic lines pre-assembled to the lubricator;
 Connect the servicing unit to the pneumatic supply at site;
 Check the pneumatic control operations for proper performance.

To operate the lift, do as follows:

 Move the lift close to the wheel to be lifted;

 Put down the switch lever (ref. fig. 3) to let the lift lower at the minimum height;

 Place the wheel on the arms properly;

 Raise the lift by putting up the switch lever (ref. fig. 3);

 Rest the lift at a desired height by releasing the switch lever;

 Place the wheel onto the tire changer or the wheel balancer carefully;

 Move the lift out of the working space.

 

Figure3 - GENERAL ASSEMBLY
1.Column assembly

2.Screw M10X25

3.Washer D.10

4.Base

5.Left foot

6.Nut M10

7.Screw M8X20

8.Washer D.8

9.Nut M8

10.Screw M10X30

11.Right foot

12.Caster 3”

13.Screw M6X12

14.Wheel arm unit

15.Locking washer D.8

16.Arm support

17.Bearing 6203

18.Arm shaft

19.Arm roller

20.Washer D.8

21.Screw M8X16